4 Types of Climbing Harnesses


Climbing Harnesses

A harness, belt or saddle, depending on where the climber hangs their hard hat or helmet, is an intimate part of every working day, often spending a lot more time in contact with the user’s body than anything else in their life.

There are four basic types of industrial harnesses and many tree industry specific harnesses will have elements of each one:

Fall restraint: This system is meant to prevent the user from getting into a position where they can fall. It’s pretty limited in tree work and would most commonly be seen in the use of a body belt with the appropriate lanyard in an aerial lift or device. The right length lanyard used with a fall-restraint harness is the key component, as it is what prevents the user from getting to a spot where a fall could occur.

Fall arrest: This system is supposed to stop a fall, as well as lessen the forces and possible iHampton Roadsuries. In tree care, these types of systems are most often called full-body harnesses and are often used in aerial lifts, though some can also be used for climbing.

Work positioning: This gives the climber the ability to position themselves safely and correctly to carry out the needed work, preventing a fall while keeping the hands free. Side attachment points or D-rings are a good example of work positioning.

Suspension: Its purpose is to sort of cradle the climber in an upright, slightly seated position while tied in above. When set up properly, it can also allow stable work positioning with both hands free.

Source: Tree Services, October 2012

The post 4 Types of Climbing Harnesses appeared first on Tree Services.

Source link